BLADEZ PB-SM 816 Troubleshooting Guide download pdf (Page 12)

Bladez Corp. • 20155 Ellipse • Foothill Ranch, CA 92610 • (866) 325-2339 • www.ebladez.com

Page 11

Your XTR-SE has a variable speed throttle lever. You can control the speed of your

scooter by the amount of pressure you use when depressing the throttle lever. The

more you depress the throttle lever the faster you will go.

To stop, release the accelerator handle and depress the BRAKE LEVER on the left side

of the handlebars. Depressing the brake will disengage power to the motor.

When the unit feels like it is losing power, or not accelerating to full speed you are ready

to RECHARGE.

*NOTE: At this time there is still a charge in the batteries, but it is not advisable to

discharge them fully.

FOLDING AND STORAGE

When you are done riding the XTR-SE you can fold it down for compact storage,

carrying and transportation. Make sure the POWER SWITCH is in the OFF position and

the charger is unplugged from the socket.

Always charge your POWER BOARD fully prior to storage!

To fold down the XTR-SE, use one hand to pull back on

the FOLDING HANDLE while using the other to gently pull

down on the handlebars (Fig.12). BE CAREFUL NOT TO

HIT YOUR HEAD WITH THE HANDLEBAR. Push down

until you feel the mechanism lock into place.

RECOMMENDED TOOLS

To adjust and service the Bladez XTR-SE Power Board you will need the following

tools:

Allen Keys: 3/4/5/6mm.

Wrenches: 8/10/13/14/17 mm Open and ring combination.

Large Adjustable Crescent Wrench

Philips Head Screwdriver

Oil, Grease or Lubricant (such as WD-40)

BRAKING SYSTEM

The XTR-SE uses a front wheel disc/caliper system activated by a hand lever (on the

left side of the handlebar). The brake is activated by squeezing the BRAKE LEVER with

your left hand. The XTR-SE is equipped with a controller that temporarily disengages

the power to the motor when the BRAKE LEVER is depressed.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17

No comments

BLADEZ PB-SM 816 Troubleshooting Guide Page 12