BLADEZ PB-SM 816 Troubleshooting Guide download pdf (Page 9)

Bladez Corp. • 20155 Ellipse • Foothill Ranch, CA 92610 • (866) 325-2339 • www.ebladez.com

Page 8

CHARGING SYSTEM

This unit comes standard with a regulated charger.

Charging

Your XTR-SE should come charged out of the box. Bladez still recommends charging

the unit for 6-8 hours prior to first use! Bladez also recommends charging your XTR-SE

after every use and prior to storage.

NOTE: It is not advisable to leave your Power Board plugged in for more than 24 hours.

Warning: DO NOT allow your Power Board to go into deep discharge! – This will

damage the batteries.

ALWAYS CHARGE YOUR POWER BOARD PRIOR TO STORAGE.

Charging Your Scooter

1. Carefully remove the XTR-SE from the box.

2. Make sure the unit is turned OFF.

3. Uncover the charging jack by rotating the

safety cover as shown (Fig. 9).

4. Locate the picture of your charger in the

chart on the following page and follow the

instructions for your charger.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17

No comments

BLADEZ PB-SM 816 Troubleshooting Guide Page 9