BLADEZ MOBY XS PB-SE823 User Manual download pdf (Page 13)

Bladez Corp. • 20155 Ellipse • Foothill Ranch, CA 92610 • (866) 325-2339 • www.ebladez.com

Page 12

WARNING!

When the engine is idling, under no circumstances should your MOBY

XS be moving.

If the MOBY XS continues to move after idle speed adjustment, contact

Bladez or your local Bladez service center.

Tires And Wheels

The Bladez MOBY XS uses an identical rim and tire assembly on the front and rear

wheel, which means that the tires can be rotated. The wheels are actually two wheel

halves (split rim) bolted together to make it easier to remove and replace the tire and

tube.

Tire wear will differ based on rider weight, riding conditions and care. Replacement

tires can be obtained at your local Bladez dealer, through motorcycle shops, or from

the Bladez website at www.ebladez.com

Tire Pressure

The tire must be inflated to a maximum of 60 P.S.I. It is also recommended to

use a tube additive like Slime

available from any motorcycle shop, to avoid

inconvenient punctures.

WARNING!

Empty all air from the tire

, prior to loosening the bolt to split the rim.

Chain Adjustment

The chain will come adjusted from the factory. However, it may be necessary to

adjust the chain from time to time.

How Tight Should The Chain Be?

 If the chain is skipping or jumping on the sprocket teeth, it is too loose and

should be adjusted.

 The chain should be tight enough not to skip, but have a little bit of play.

Adjusting The Chain

1. Loosen the rear axle bolt but do not

remove the axle.

2. Tighten or loosen the rear axle tension

screws until you find the proper chain

tension. (Fig. 11) (About 1/8 of an inch

of play will be the proper tension for your

chain)

1 2 ... 8 9 10 11 12 13 14 15

No comments

BLADEZ MOBY XS PB-SE823 User Manual Page 13