BLADEZ MOBY XS PB-SE823 User Manual download pdf (Page 11)

Bladez Corp. • 20155 Ellipse • Foothill Ranch, CA 92610 • (866) 325-2339 • www.ebladez.com

Page 10

OPERATING PROCEDURES

Fuel

WARNING!

This is a two-stroke engine. Only run the engine on fuel, which is properly

mixed with 2-cycle engine oil.

Provide good ventilation when fueling or handling fuel.

 Always use gas with a minimum octane number of 90.

 Use 2-stroke engine oil only. Mix 50:1 gas / oil mixture.

 Never use multi-grade (10W/30) or waste oil.

 Always mix fuel and oil in a separate clean, gas safe container. Always

start by adding half the amount of fuel which is to be used. Then add the

whole amount of 2-cycle oil. Mix (shake) the fuel container. Add the

remaining amount of fuel. Mix (shake) the fuel-oil thoroughly before filling

the fuel tank.

Fueling

WARNING!

 Always shut the engine off before you refuel.

 Slowly open the fuel tank, so that possible over-pressure disappears.

 Before fueling, clean the tank cap area carefully, to insure that no dirt falls

into the tank. Make sure that the fuel is well mixed by shaking the

container.

 Tighten the fuel cap carefully, after fueling.

 Always move the unit at least 10 feet from the fueling area before starting.

Starting

 Set the CHOKE LEVER to the CLOSED (UP) position.

 Pull the recoil starter handle briskly, making sure to keep the handle in

your grasp, and not allowing it to snap back.

 Once the engine is running, move the CHOKE LEVER to the RUN

(DOWN) position.

Note!

At this stage, if the engine does not start, repeat the starting procedure.

 After starting the engine, allow the engine 2-3 minutes to warm up prior to

riding.

Stopping

 Gradually decrease the engine speed to an idle speed and press the kill-

switch on the handlebar tube.

1 2 ... 6 7 8 9 10 11 12 13 14 15

No comments

BLADEZ MOBY XS PB-SE823 User Manual Page 11