BLADEZ ION 150 Troubleshooting Guide download pdf (Page 11)

Tire wear will vary based on rider weight, riding conditions and care. Replacement tires

can be obtained at your local Bladez dealer, through motorcycle shops, or from the

Bladez website at www.ebladez.com. The Bladez ION uses a standard Innova 2.00 x 50

front pneumatic tire and a 150mm rear solid tire.

Tire Pressure

The front tire must be inflated to a maximum of 40 P.S.I. It is also recommended to use a tube

additive like Slime available from any motorcycle shop, to avoid inconvenient punctures.

BELT DRIVE

The Ion uses a belt drive system.

Belt Adjustment

The belt may need to be adjusted from time to time. Please follow the directions below

to adjust your belt.

1. Using a screwdriver remove the plastic

covers on each side of the rear wheel

(Fig. 8).

2. Use a 16mm wrench to loosen the axle

bolts. Once the axle bolts are loose, use a

10mm wrench to loosen the tension bolts

behind the rear wheel of the ION and move

the rear wheel backwards to remove the

slack from the belt (Fig. 9).

3. Once this is achieved the wheel nuts must

then be relocked into position and wheel

alignment must be checked (while turning

the wheel, visually check that the clearance

between the wheel and the frame parts

have clearance).

Fig. 8

Fig. 9

1 2 ... 6 7 8 9 10 11 12 13

No comments

BLADEZ ION 150 Troubleshooting Guide Page 11